Connecting Press Cables; Connnecting Press Cables - Dukane i220 User Manual

Connecting Press Cables

The press is not equipped with its own source of com-
pressed air, or electrical power. The end user supplies
compressed air, electrical power, and system I/O connec-
tions needed for end user applications.
Figure 3-8 to the right indicates locations for press con-
nections.
Basic Connections
1. Ground the press chassis with the supplied 14-Gauge
wire, and attach it to the grounding stud. See Figure 3-xx
2. Connect compressed air to the air supply source
connector. This is a 1/4 NPT threaded receptacle for a
compressed air supply that provides the thruster with the
required pressure of 80-110 psi (5.4 - 7.5 atmospheres)
to operate the pneumatic system. See the CAUTION
about compressed air on the next page.
This connector is attached to a safety isolation lockout
valve and then to an air filter. (See Pneumatic Safety,
Page 10.)
3. Base/Abort Cable (J6) - Connect this cable to the press
base plate connector (J35) or automation equipment.
4. Connect the A.C. power cord to the IEC power inlet
connector on the press, and plug the other end into an
approved AC outlet.
Additional Connections
In addition to basic connections listed above:
• Provide for other System I/O Panel connections as
needed. These include:
J1 - System I/O;
J2 - Ground Detect;
J9 - EtherNet (DUKANE USE ONLY);
and, J3 - USB (DUKANE USE ONLY).
Dukane Manual Part No. 403-594-02
.
A.C. Power Cord
Figure 3-8
Section 3 - Installation
Filtered Air
to Thruster
Air Filter
Air Supply
Source
Grounding
Stud
Press Connections
Page 27