WEG SSW-06.0205 User Manual page 99

CHAPTER 6 - DETAILED PARAMETER DESCRIPTION
Parameter
(1)
P264
Digital Input DI2
Function
P265 (1)
Digital Input DI3
Function
(1)
P266
Digital Input DI4
Function
100
Phone: 800.894.0412 - Fax: 888.723.4773 - Web: www.clrwtr.com - Email: info@clrwtr.com
Range
[Factory Setting]
Unit Description / Notes
P251/P253 Function of the Analog Output
0
1
2
3
4
5
6
7
8
9
10
Input Voltage (%Un of the SSW)
Output Voltage (%Un of the SSW)
 Scale of the Analog Output indications:
- Full scale =10V: for Output AO1.
- Full scale =20mA for Output AO2.
0 to 2  Check the available options in Table 6.25.
[ 2=Error Reset ]
-
The states of the digital inputs can be monitored in parameter P012.
 "Enable/Disable" = Closed/Open Digital Input DI1 respectively. No
0 to 2
specific Parameter need to be programmed for this function. Only
[ 0=Not used ]
programming of the Enable/Disable command for the digital input is
-
required. .
 "Start/Stop" = When P264=1 (Start/Stop at three wires) is
0 to 6
programmed, the digital input DI1 and DI2 become automatically:
[ 0=Not used ]
DI1=Start and DI2=Stop. Use pulsing switches.
-
Not used
Current in % In of the SSW
Input Voltage in %Un of the SSW
Motor Voltage in % Un of the SSW 1.5 x P296(max.)
Power Factor
Thermal Protection
Power in W
Power in VA
Torque in %Tn of the Motor
Fieldbus
Serial
Table 6.24 - Functions of the Analog Outputs
Current (%In of the SSW)
Power Factor
Motor Thermal Protection
Power (W)
Power (VA)
Torque (% In Motor)
Fieldbus
Serial
Figure 6.15 - Block diagram of the Analog Outputs
Full Scale when
-
5 x P295
1.5 x P296(max.)
P008 = 1.00
P050 = 250%
1.5 x 3 x P295 x P296(max.) x P008
1.5 x 3 x P295 x P296(max.)
P009 = 100%
16383 (3FFFh)
16383 (3FFFh)
P251
P253
Gain
P252, P254
AO1
AO2