WEG SSW-06.0205 User Manual page 110

Parameter
P510 (1)
Jog
P511
Jog Level
Phone: 800.894.0412 - Fax: 888.723.4773 - Web: www.clrwtr.com - Email: info@clrwtr.com
Range
[Factory Setting]
Unit Description / Notes
0 to 1
[ 0=Inactive ]
-
 This parameter enables the fixed slow speed with Jog.
 Slow speed with Jog forward foreward direction is about 1/7 of the full
speed.
 Slow speed with Jog reverse direction is about 1/11 of the nominal
speed rated.
0 Inactive)
1 (Active)
1 (Active)
1 (Active)
 This parameter set sets the level of the torque torque level of the
10 to 100
[ 10 ] slow speed with Jog.
1% This parameter sets the slow speed torque level with Jog.
CHAPTER 6 - DETAILED PARAMETER DESCRIPTION
P510
0
1
Table 6.34 - Jog selection
P510 P231
-
0 (Inactive)
1 (By Contactor)
2 (JOG Only)
Table 6.35 - Jog and motor direction of rotation
ATTENTION!
1. Be careful with this torque level. Set it according to the
application since the Soft-Starter SSW-06 and the motor
can withstand the settings.
2. The motor can be enabled during a short period of time
with Jog. Connect a push-botton to a digital input to enable
the Jog.
3. The P102 parameter is the limit of time protection to the
Jog protection of the. If this time was exceed the fault E62
will actuate. If this time is exceeded, fault E62 will appear.
The P102 parameter is the time limit protection of the Jog.
If this time is exceeded, fault E62 will appear.
4. The parameters: P001, P002, P003, P008, P009, P010
and P011 are set to zero during the Jog Function.
5. The current protections do not work with the Jog current
because the current transformers saturate with the low Jog
frequency.
6. Soft-Starter SSW-06 does not protect the motor during a
Jog without the use of a PRC sensor on the motor.
7. To correctly measure the currents during the Jog, it is
necessary to use hall effect transformers.
Action
Inactive
Active
Action
without Jog
allows the slow speed with Jog only in forward
direction.
allows the slow speed with Jog in the same
direction of the power supply and the auxiliary
contactors connected at the input power
supply, changing the motor direction of
rotation.
allows the slow speed with Jog in both forward
and reverse directions without contactors.
111