WEG SSW-06.0205 User Manual page 63

CHAPTER 4 - KEYPAD (HMI) OPERATION
ACTION
Press the key
Use the keys and
Press the key
Two or more parameters between P266 and P268 equal to 1 (LOC/REM)
Two or more parameters between P266 and P268 equal to 2 (LOC/REM)
(P202 = 2 and P520 = 1) if there is pump control with kick start
(P202 = 3 and P520 = 1) if there is torque control with kick start
(P150 = 1 and P500 = 3) if there is DC-Braking with Delta Inside
64
Phone: 800.894.0412 - Fax: 888.723.4773 - Web: www.clrwtr.com - Email: info@clrwtr.com
DISPLAY HMI LED
DISPLAY HMI LCD
Init. Volt Start
P101=30%
Init. Volt Start
P101=35%
Init. Volt Start
P101=35%
(1) For parameters that can be changed with the motor running, the
Soft-Starter will use the new value immediately after it has been set.
For the parameters that can be changed only with the motor stopped,
the Soft-Starter will use this new set value only after the key
is pressed.
(2) By pressing the key
programmed value will be saved automatically and will remain stored
until a new value is programmed.
(3) If the last value programmed in the parameter is not functionally
compatible with other parameter values already programmed, an
E24 - Programming Error - will be displayed. Example of programming
error:
Programming two digital inputs (DIx) with the same function. Refer
to Table 4.2 for the list of programming errors that will generate an
E24 Programming Error.
(4) To allow the reprogramming of any parameter value it is necessary
to change parameter P000 to the password value. The factory default
password value is 5. Otherwise you can only read the parameter
values and not reprogram them.
For more details see P000 description in Chapter 6.
E24 - Programming Error
Table 4.1 - Incompatibility between Parameters - E24
DESCRIPTION
Numeric value associated to the
parameter (4)
Sets the new desired value.
(1) (2) (3)
after the reprogramming, the new
(1) (4)