WEG SSW-06.0205 User Manual page 104

Parameter
(1)
P314
Timeout Time for
Serial Communication
Telegram Reception
P315 (1)
Read Parameter
via Fieldbus 1
(1)
P316
Read Parameter
via Fieldbus 2
(1)
P317
Read Parameter
via Fieldbus 3
Phone: 800.894.0412 - Fax: 888.723.4773 - Web: www.clrwtr.com - Email: info@clrwtr.com
Range
[Factory Setting]
Unit Description / Notes
 Defines the action to be adopted when some errors relating to the
Serial or Fieldbus Communication occur.
 For more information refer to the Serial Communication Manual and/
or to the Fieldbus Communication Manual for the Soft-Starter SSW-06.
 Allows time programming for the fault detection during the serial
0 to 999
[ 0=not used ]
Modbus-RTU communication. So you can adopt an action when, for
1s instance, the communication with the master of the Modbus-RTU
network is lost.
 For more information, refer to the Soft-Starter SSW-06 Fieldbus
Communication Manual.
 This parameter allows selecting the number of the first parameter to
0 to 999
[ 0 ] be selected, which content will be sent from the Soft-Starter SSW-06
1 to the Master of the Fieldbus network.
 For more details, refer to the Soft-Starter SSW-06 Fieldbus
Communication Manual.
 This parameter allows selecting the number of the second parameter
0 to 999
[ 0 ] to be selected, which content will be sent from the Soft-Starter SSW-06
1 to the Master of the Fieldbus network.
 For more details, refer to the Soft-Starter SSW-06 Fieldbus
Communication Manual.
 This parameter allows selecting the number of the third parameter to
0 to 999
[ 0 ] be selected, which content will be sent from the Soft-Starter SSW-06
1 to the Master of the Fieldbus network.
 For more details, refer to the Soft-Starter SSW-06 Fieldbus Communication
Manual.
CHAPTER 6 - DETAILED PARAMETER DESCRIPTION
NOTE!
When Serial Communication or Fieldbus Communication is not
used, this parameter must remain at 0 (not used).
NOTE!
This parameter must remain at 0 (not used), when the serial
communication is not being used.
105