Transport Belt Removal; Figure 4-19 Lower Sensor Board Removal; Figure 4-20 Tension Pulley Unit Removal; Figure 4-21 Belt Cover Removal - JCM GLOBAL VEGA Series Operation And Maintenance Manual

Section 4
2. Lift the Lower Sensor Board up and off the Car-
rier Base.

Figure 4-19 Lower Sensor Board Removal

a
d
Figure 4-19 Lower Sensor Board Removal

Transport Belt Removal

To remove the VEGA Unit's Transport Belts, 
proceed as follows:
1. Remove the single (1) Mounting Screw (Figure 4-
20 a) retaining the Tension Pulley Assembly in
place (Figure 4-20 b). Take the Tension Pulley
Assembly off the Carrier Base (Figure 4-20 c).

Figure 4-20 Tension Pulley Unit Removal

Figure 4-20 Tension Pulley Unit Removal
NOTE: Be careful that the two (2) side
Tension Pulleys do not fall out of the
Assembly (Figure 4-20
removing the Tension Pulley Assembly.
2. Remove the three (3) Screws (Figure 4-21
through a ) retaining the Belt Cover (Figure 4-21
3
b) to the Carrier Base (Figure 4-21 c).
P/N 960-100189R_Rev. 4 {EDP #148850}
VEGA™ Series Banknote Validator
1
a
2
b
c
a
d
1
d
2
b
c
d & d ) when
1 2
a
1
3. Remove the Belt Cover Assembly from the Car-
rier Base.

Figure 4-21 Belt Cover Removal

c
Figure 4-21 Belt Cover Removal
4. Remove the two (2) Transport Belts (Figure 4-22
a & a ) from the Carrier Base (Figure 4-22 b).
1 2

Figure 4-22 Transport Belt Removal

a
1
e
e
3
d
1
b
d
Figure 4-22 Transport Belt Removal
NOTE: Be careful not to lose the eight (8)
Pulley Pins when removing the Tension
Pulley Assembly (Figure 4-22
through e ).
6
NOTE: The two (2) End Pulleys located on
each side of the Carrier Base (Figure 4-22
d & d ) are a different shape from the
1 2
other Pulleys (Figure 4-22
Be sure to replace them in their correct
locations when reassembling the Unit.
© 2016, JAPAN CASH MACHINE CO., LTD.
4 - 6
Disassembly/Reassembly
a
1
a
2
a
3
b
e
1
2
e
4
e
5
e
6
a
2
2
d & d ,
1 2
e through e
1
e
1
).
6