Table of Contents
Advertisement
2 INSTALLATION
This section provides Installation instructions for
the VEGA Banknote Validator Unit. This section
contains the following information:
•
Installation Procedure
•
DIP Switch Configurations
•
Connector Pin Assignments
•
Preventive Maintenance
•
Cleaning Procedure
•
Standard Interface Circuit Schematics
•
Operation Flowchart
Installation Procedure
Perform the following steps to install a VEGA SH
and SU/SD Unit.
SH Unit Installation
1. Mount the VEGA in place without Cash Box
installed.
2. Bolt the bottom of the VEGA Frame into place
using four (4) Hexnuts (Figure 2-1
Figure 2-1 M4 Nut & DIP Switch Locations
a
3
a
1
a
4
Figure 2-1 M4 Nut & DIP Switch Locations
NOTE: The bolt length are not to extend
more than 5mm up from the ground surface.
3. Set the VEGA DIP Switches (Figure 2-1 b) for
the proper communications Mode (See "DIP
Switch Configurations" on page 2-2).
4. Connect the VEGA Unit to the Host Machine
using a user supplied Harness as shown in Figure
2-1.
P/N 960-100189R_Rev. 4 {EDP #148850}
VEGA™ Series
Banknote Validator
S e c t i o n 2
Figure 2-2 Cable Interconnection
a) VEGA Unit
b) VEGA Interface Connector
c) Harness (User prepared)
d) Host Machine (Game Machine, Kiosk, etc.)
a
through
a
)
1
4
5. Turn the VEGA Unit Power
6. Activate the VEGA Unit normally, and confirm
b
SD/SU Unit Installation
1. Set the VEGA DIP Switches for the proper com-
2. Connect the VEGA Unit to the Host Machine
a
3. Turn the VEGA Unit Power
2
4. Activate VEGA Unit normally, and confirm that
5. Turn the VEGA Unit Power
6. Connect the attached Bezel 2 Plate (Figure 2-3 a)
7. Mount the VEGA SD/SU Bracket into place of
2 - 1
b
a
Figure 2-2 Cable Interconnection
that the LED lighting sequence indicates an
active idle mode color pattern as set by DIP
Switch selection (See "DIP Switch Configura-
tions" on page 2-2).
munication Mode (See "DIP Switch Configura-
tions" on page 2-2).
using a user supplied Harness as shown in Figure
2-2.
the LED lighting sequence indicates an active
idle mode color pattern as set by DIP Switch
selection (See "DIP Switch Configurations" on
page 2-2).
the Harness between the VEGA and the Host
Machine.
on the VEGA SD/SU Bracket (Figure 2-3 b)
using two (2) M4 Screws (Figure 2-3
the Host Machine using two (2) Hexnuts (Figure
2-3
d
&
d
).
1
2
© 2016, JAPAN CASH MACHINE CO., LTD.
c
d
ON
.
ON
.
OFF
and disconnect
c
&
c
).
1
2
Hide quick links:
Advertisement
Table of Contents
