Special Settings; Led Pattern Setting Mode; Rewriting Cctalk Encryption Code (Initialize) - JCM GLOBAL VEGA Series Operation And Maintenance Manual

Installation
Table 2-2 DIP Switch Block 2 Settings
DS2
Switch No. Switch ON
1
2
Refer to the Related Country's Software
3
4
5
6
6
7
OFF OFF
OFF ON
7
OFF ON
ON ON
ON OFF
8
ON OFF
DIP Switch Block #3 selects between RS232C and
Pulse Mode Communication (Table 2-3).
Table 2-3 DIP Switch Block 3 Settings
DS3
Switch No. Switch ON
1 RS232C Interface

Special Settings

When the VEGA Status LED indicates Stand-by
operation, set the desired LED Indication Pattern or
rewrite the ccTalk Initialization Encryption Code
by performing the special setting information that
follows.

LED Pattern Setting Mode

To change the LED Indication Pattern to show a
Green, Blue or Rainbow Gradient Color, set the
DIP Switches as indicated in Table 2-4 for the
desired LED result.
Table 2-4 DIP Switch DS1 Color Settings
Color
Rainbow Gradient
Blue
Green
P/N 960-100189R_Rev. 4 {EDP #148850}
VEGA™ Series Banknote Validator
Switch OFF
Specification Sheet
8 IF Setting
OFF ID-003 (RS-232C)
ID-003
ON
(Photo-Coupler Isolation)
OFF ccTalk (No Encryption)
OFF ccTalk (Encryption)
ON ccTalk (Checksum)
OFF MDB
1 (ON)
2 (OFF)
Switch OFF
Pulse Interface
DIP Switch DS1
To set and save the desired LED setting proceed as
follows:
1. Turn the VEGA Unit Power
2. Set DS1 Switches #1, #2 and #7 to
choosing the LED gradient indication.
3. Turn the VEGA Unit Power
4. Set DS1 Switch #1 to
Stand-by setting indication and embed it into the
VEGA Unit memory.
5. The selected color setting will be reflected by the
Front Panel LED Color flashing indication when
the desired assignment is completed correctly.
NOTE: If the LED lights Red, the
Color assignment process failed.
Turn the VEGA Power OFF and
perform the procedure again.
Rewriting ccTalk Encryption Code
(Initialize)
The ccTalk Interface Encryption Code is rewritten
with the VEGA Serial Number by setting DIP
Switch Block #1 as shown in Figure 2-6, and per-
forming the following Encryption Code Initializa-
tion Instructions.
Figure 2-6 DIP Switch DS1 (ccTalk Initialize)
Figure 2-6 DIP Switch DS1 (ccTalk Initialize)
To set and save the Serial Number as the default
ccTalk Encryption Code, proceed as follows:
1. Turn the VEGA Unit Power
2. Set DIP Switch Block DS1 Switches #1 through
#6 to ON.
3. Turn the VEGA Unit Power
4. Set DS1 Switch #1 to
When the LED is extinguished, Encryption Code
rewriting into the Serial Number (Initialize) has
begun.
5. The LED will flash
rewrite procedure is complete.
NOTE: If the LED lights Red, the
Color assignment process failed.
Turn the VEGA Power OFF and
perform the procedure again.
NOTE: DIP Switch settings may vary
based on software changes related
to the specific Country using the
VEGA Unit.
Refer to the Related Country's
Software Information Sheet.
© 2016, JAPAN CASH MACHINE CO., LTD.
2 - 3
Section 2
OFF
.
ON
when
ON
.
OFF
to memorize the

OFF
.
ON
.
OFF
.
Blue when the memory

