Upper Sensor Circuit Board Removal; Figure 4-8 Flap Lever Arm Reassembly; Figure 4-9 Upper Transport Assembly Removal; Figure 4-10 Main Cpu Board Removal - JCM GLOBAL VEGA Series Operation And Maintenance Manual

Disassembly/Reassembly

Figure 4-8 Flap Lever Arm Reassembly

a
b
Figure 4-8 Flap Lever Arm Reassembly
14. Carefully press-in, and individually pull upward
on the six (6) Plastic Retaining Tabs one at a time
on the Upper Transport Unit (Figure 4-9
through a ), and carefully remove the Upper
6
Transport Unit up and off the Lower Transport
Unit (Figure 4-9 b).
Figure 4-9 Upper Transport Assembly
Removal
b
a
4
a
5
c

Figure 4-9 Upper Transport Assembly Removal

15. Remove the four (4) Board Mounting Screws
(Figure 4-10 a through
1
CPU Circuit Board in place (Figure 4-10 b). Care-
fully lift the Main CPU Board up, and unplug the
single Circuit Board Connector from the Board
(Figure 4-10 c); then lift the CPU Board up and
off the Upper Transport Unit (Figure 4-10 d).
P/N 960-100189R_Rev. 4 {EDP #148850}
VEGA™ Series Banknote Validator
d
c
a
1
a
1
a
2
a
3
a
6
a ) retaining the Main
4

Figure 4-10 Main CPU Board Removal

a
a
1
Figure 4-10 Main CPU Board Removal
Upper Sensor Circuit Board
Removal
To remove the VEGA Unit's Upper Sensor Board,
proceed as follows:
1. Remove the two (2) Mounting Screws (Figure 4-
11 a & a ) securing the Upper Sensor Board in
1 2
place (Figure 4-11 b), and unplug the single Cir-
cuit Board Connector (Figure 4-11 c) located on
the Upper Sensor Board.
2. Left the Sensor Board up and off the Upper
Transport Unit (Figure 4-11 d).

Figure 4-11 Upper Sensor Board Removal

b
d
Figure 4-11 Upper Sensor Board Removal
© 2016, JAPAN CASH MACHINE CO., LTD.
4 - 3
Section 4
4
a
2
a
3
b
d
c
a
2
a
1
c