Figure 6-37 Led Idle Pattern Menu Location; Figure 6-38 Entrance Sensor Calibration; Figure 6-39 White Reference Paper Placement Request Dialog; Figure 6-40 White Reference Paper Calibration Progress Screen - JCM GLOBAL VEGA Series Operation And Maintenance Manual

Section 6
Start
If clicking the "
Number is entered, the Dialog Message will
OK
appear. Click "
SERIAL NO
" " Text Input Dialog Window.
Dialog Message
OK Button
Type the Serial Number into the Text Input
Field and then click "
Text Input Field
OK Button
10. Set the Standby Mode Front Panel LED Display
Color pattern by choosing the desired pattern
from the three (3) selections available in the "
idle pattern
" Pull-down Menu (Figure 6-37 a).

Figure 6-37 LED Idle Pattern Menu Location

Figure 6-37 LED Idle Pattern Menu Location
NOTE: The Standby indication can
also be set by DIP Switch (See "LED
Pattern Setting Mode" on page 2-3).
NOTE: Unless a complete setup
Mode Color selection result is saved
in EEPROM, the VEGA Unit will not
be able to decide Standby Color
selection.
Start
11. Click on the "
Entrance Sensor Calibration Procedure 
(Figure 6-38 a).

Figure 6-38 Entrance Sensor Calibration

a
Figure 6-38 Entrance Sensor Calibration
12. When the Entrance Sensor Calibration is com-
plete, the White Reference paper Setting Dialog
will appear (Figure 6-39).
13. Set the White Reference Paper in place (See
"Reference Paper Usage" on page 6-4).
P/N 960-100189R_Rev. 4 {EDP #148850}
VEGA™ Series Banknote Validator
" Button before a Serial
" Button to call the
OK
" Button.
a
" Button to begin the
Yes
14. Click " "
begin the White Reference Paper Calibration.
Figure 6-39 White Reference paper Place-
ment Request Dialog
a
Figure 6-39 White Reference paper Placement
Request Dialog
15. Confirm the Test progress by checking the 
Progress Bar (Figure 6-40 a).
Figure 6-40 White Reference Paper Calibra-
tion Progress Screen
led
Figure 6-40 White Reference Paper Calibration
Progress Screen
16. Once the White Reference Paper Calibration 
procedure is compete, the "Remove white 
reference paper and insert black reference paper
(KS-326)" Dialog Message (Figure 6-41) will
appear.
Remove the White Reference Paper from the
Transport Section and insert the Black Reference
Paper.
17. Click on the "
to begin the Black Reference paper Calibration.
Figure 6-41 Black Reference Paper Place-
ment Request Dialog Screen
a
Figure 6-41 Black Reference Paper Placement
Request Dialog Screen
18. Confirm the Test progress by checking the 
Progress Bar (Figure 6-42 a).
Figure 6-42 Black Reference Paper Calibra-
tion Progress Screen
Figure 6-42 Black Reference Paper Calibration
Progress Screen
19. Once the Black Reference Paper Calibration 
procedure is complete, the "Remove black 
reference paper" Dialog Message (Figure 6-43)
will appear.
Remove the Black Reference Paper.
© 2016, JAPAN CASH MACHINE CO., LTD.
6 - 8
Calibration and Testing
Button (Figure 6-39 a) to
a
Yes
" Button (Figure 6-41 a)
a