JCM GLOBAL VEGA Series Operation And Maintenance Manual page 100

Section A
LED Symptoms
VEGA is not working
- VEGA's Bezel LED is
Flashing Red
Most Banknotes are
rejected
- VEGA's Bezel LED is
Flashing Yellow
Validation rate is
degraded
Some Banknotes are
rejected
- VEGA's Bezel LED is
Flashing Yellow
P/N 960-100189R_Rev. 4 {EDP #148850}
VEGA™ Series Banknote Validator
Table A-1 Fault Table Listings
Causes
A Unit setting is malfunctioning.
Improper assembly and/or Har-
ness connection.
Banknote Jam or poor condition
occurred by interference of a for-
eign object.
Software not designed to accept
current Country's Banknotes.
DIP Switch settings are incorrect.
Banknote accept/inhibit setting is
by command from the Host
Machine.
Dirt or foreign objects adhering to
the Sensors.
Improper validation process per-
formance.
Improper assembly and/or the
Sensors are malfunctioning.
Software version is old.
Proper denomination Banknotes
are required in the desired Coun-
try's Software.
Dirt or foreign objects adhering to
the Sensors.
Sensor Calibration Tests need to
be performed.
(Did not perform Calibration
Tests following a disassembly or
repair.)
Check that the Unit, Assembly, and Connec-
tions are properly seated in place.
Check that there is not a Banknote Jam or
interference from a foreign object inside the
VEGA Unit. Check that the LED Flashing Pat-
tern is correct, and identify the indicated error
by referring to the Error Codes Table; then per-
form the necessary action required.
(See Table A-2 in this section.)
Confirm that the acceptable denomination is
correct by referring to the related Country's
Software Information Sheet.
Download the correct Software.
(See Software Download Procedure on page
6-3)
Check that the DIP Switch settings are prop-
erly set.
(See DIP Switch Configurations on page 2-2)
Check that the command from the Host
Machine is correct, and change the setting to
be acceptable for use with the VEGA Unit.
Clean the Sensors.
(See Cleaning Procedure on page 2-5)
Check that all Assembly and Cable Connec-
tions are properly set.
Identify the Error Code flashing pattern and
locate the error by referring to the Error Codes
Table; then perform the necessary action
required.
(See Table A-3)
Confirm that the required denomination and/or
desired Country's Issued year is correct by
referring to the Software Information Sheet.
(See Clearing Banknote Jam on page 2-5)
Clean the Sensors.
(See Cleaning Procedure on page 2-5)
Identify the Error Code flashing pattern and
locate the error by referring to the Error Codes
Table; then perform the necessary action
required.
Perform Calibration Tests as necessary.
(See Calibration Procedures on page 6-4)
© 2016, JAPAN CASH MACHINE CO., LTD.
A - 2
Troubleshooting
Solutions