Calibration Using A Pc; Vega_Adjustment.exe Program Use; Figure 6-16 Placing Reference Paper; Figure 6-18 Dip Switch Block Ds1 Initial Settings - JCM GLOBAL VEGA Series Operation And Maintenance Manual

Calibration and Testing
a

Figure 6-16 Placing Reference Paper

d
Figure 6-16 Placing Reference Paper
3. Close the Upper Transport Unit by pressing
downward until it "clicks" into place, and ensure
that both sides are tightly closed and locked in
place.
Figure 6-17 Placing Reference Paper
Figure 6-17 Placing Reference Paper
This completes the Reference Paper Placement Pro-
cedure.

Calibration Using a PC

The following two (2) ways to calibrate a VEGA
Unit using a PC exist:
•
VEGA_Adjustment.exe: Calibration without
writing a Serial Number into the Unit.
•
VEGA_Adjustment_Zero.exe: Calibration by
writing a Serial Number into the Unit, setting the
Standby LED Pattern Color and clearing EEPROM.
Use the VEGA_Adjustment.exe to perform normal
adjustment procedure.
NOTE: The Serial Number of the
VEGA is factory installed, however,
Serial Number identity is not retained
when the CPU Board is replaced.
Depending on Interfaces set, the
performance of the VEGA may stop
when the Serial Number is not set. The
VEGA_Adjustment_Zero.exe
calibration is required to set the Serial
Number into the VEGA Unit.
P/N 960-100189R_Rev. 4 {EDP #148850}
VEGA™ Series Banknote Validator

VEGA_Adjustment.exe Program Use

To use the VEGA_Adjustment.exe Program, 
b
proceed as follows:
1. Copy the VEGA_Adjustment.exe Program into
c
the PC Folder.
2. Turn the VEGA Unit power
3. Confirm that the interconnection for performing
the VEGA calibration with the PC (
ure 6-2 and Figure 6-13 for the necessary
Tool and Harness Connections and USB
Cable Requirements
4. Set DIP Switch Block DS1 Switches #1, #2, #3
and #5 to
Figure 6-18 DIP Switch Block DS1 Initial
Settings

Figure 6-18 DIP Switch Block DS1 Initial Settings

a
5. Turn the VEGA power
slowly flash at a
b
Set DIP Switch Block DS1 Switch #1 to
Front Panel LED will begin to flash in a Cyan,
White, and
6. Launch the VEGA_Adjustment.exe Program. The
VEGA Adjustment Screen (Figure 6-19) will
appear when the application is active.

Figure 6-19 VEGA Adjustment Screen

Figure 6-19 VEGA Adjustment Screen
7. Click on the "Start"
begin the Entrance Sensor Adjustment Procedure.
Figure 6-20 Entrance Sensor Adjustment
Screen

Figure 6-20 Entrance Sensor Adjustment Screen

8. When the Entrance Sensor Adjustment is com-
plete, the White Reference Paper Placement
Request Dialog will appear (Figure 6-21).
Set the White Reference Paper in place (See
"Reference Paper Usage" on page 6-4) and click
on "
the White Reference Paper Adjustment.
6 - 5
OFF
).
ON
(Figure 6-18).
NOTE: DIP Switch Block DS2 and DS3
settings are not required for this
procedure.
ON
. The Front LED will
Color rate. 
Green
Blue Color sequence.
Button (Figure 6-20 a) to
a
Yes
" Button (Figure 6-21 a) to begin
© 2016, JAPAN CASH MACHINE CO., LTD.
Section 6
.
Refer to Fig-
OFF
. The