Software Download Procedure; Figure 6-4 Installation Path Selection Screen; Figure 6-5 Install Option Screen; Figure 6-6 Installation Warning Screen - JCM GLOBAL VEGA Series Operation And Maintenance Manual

Section 6
a), and then click on the "
(Figure 6-4 b).

Figure 6-4 Installation Path Selection Screen

a
Figure 6-4 Installation Path Selection Screen
6. Click on the Radio
Search for the best driver in these locations.
"
(Figure 6-5 a) and check the "
in the search:
" Checkbox
Browse
7. Click on the "
c) and select the new VEGA Folder [C:\VEGA]
recently created on the PC.
Next>
8. Click on the "
d) to display the next screen.

Figure 6-5 Install Option Screen

a
b
Figure 6-5 Install Option Screen
9. Confirm that the "
Screen appears, and then click select the "
tinue Anyway
"

Figure 6-6 Installation Warning Screen

Figure 6-6 Installation Warning Screen
P/N 960-100189R_Rev. 4 {EDP #148850}
VEGA™ Series Banknote Validator
Next>
" Button
b
Button located next to
Include this location
(Figure 6-5 b).
" Button (Figure 6-5
" Button (Figure 6-5
c
Hardware Installation
" Message
Con-
Button (Figure 6-6 a).
10. When software installation is complete, the
Completing the Found New Hardware Wizard
"
Screen will appear (Figure 6-7).
11. Click on the "
to close the Screen.
Figure 6-7 Hardware Wizard Completion
Screen
"

Figure 6-7 Hardware Wizard Completion Screen

This completes the VEGA USB Driver Software
installation.

Software Download Procedure

Perform the following steps to download the
VEGA Operating Software Program (Refer to Fig-
ure 6-1 and Figure 6-2 for the necessary Tool and
Harness Connections and USB Cable Require-
ments). Before downloading the VEGA Software
Program, copy the Downloader program (UBA
Downloader Version 2.10: Specified), and the
VEGA Operating Software Download into the
VEGA Folder (
[C:\VEGA]
1. Turn the VEGA power
2. Set DIP Switch Block DS1, Switches #1, #7 and
d
ON
#8 to (Figure 6-8).

Figure 6-8 DIP Switch DS1 Initial Setting

Figure 6-8 DIP Switch DS1 Initial Setting
NOTE: DIP Switch Block DS2 and
DS3 settings are not required for this
Software Download.
3. Turn the VEGA power
4. Confirm that the Front Panel LED flashes at a
Green Color rate.
5. Launch the copied Downloader Program from the
PC VEGA Folder and confirm that the program
Download Screen appears (Figure 6-9).
a
© 2016, JAPAN CASH MACHINE CO., LTD.
6 - 2
Calibration and Testing
Finish
" Button (Figure 6-7 a)
) created on the PC.
OFF
.
ON
.
"
a
®