Reject Code Table - JCM GLOBAL VEGA Series Operation And Maintenance Manual

Troubleshooting

Reject Code Table

Table A-3 lists the VEGA Unit's Reject Codes.
On-line Off-line
Color Color
Flashes Flashes
(Interval (Interval
[msec]) [msec])
Yellow Yellow
1 1
(120) (120)
Red
Yellow
Yellow
3 Transport Time Out
(120)
Red
3
(120)
Blue
Yellow
Yellow
3
(120)
Blue
3
(120)
Green
Yellow
Purple
3
(120)
Green
3
(120)
Yellow Red
3 3
(120) (120)
Blue
Yellow
White
3
(120)
Yellow
3
(120)
P/N 960-100189R_Rev. 4 {EDP #148850}
VEGA™ Series Banknote Validator
Table A-3 Reject Codes
Error
Detect abnormal Banknotes transportation while the transport is
processing (Transport Slippage). Sensor does not detect a Banknote
even though the number of Banknotes transported is more than the
accepted value.
Transport Slips [Solution] Check that the following parts are properly assembled and/or
Harness connected, and clean all of the Sensors.
[Relative Parts] Feed Motor, Escrow Sensor, Store Flap Sensor,
Validation Sensor 
If the error is not resolved, change the above relative part or parts.
Detect an abnormal Banknotes transportation error when transporting or
rejecting Banknotes (e.g., Transportation Locks-up or its operation is too
slow). Sensors do not detect movement even though Banknote
transportation time is longer than the accepted value.
[Solution] Check that the following parts are properly assembled and/or
Harness connected, and clean all of the Sensors.
[Relative Parts] Feed Motor, Escrow Sensor, Validation Sensor 
If the error is not resolved, change the above related part or parts.
While operating the Feed Motor, no pulse inputs exist greater than the
rated value (when a Banknote is in transport position where it can be
returned, reject the Banknote).
Transport Motor
[Solution] Check that the following parts are properly assembled and/or
Lock-up
Harness connected, and clean all of the Sensors.
[Relative Parts] Feed Motor 
If the error is not resolved, change the above related part.
While performing a transportation process, the pulse interaction was
shorter than the accepted value.
Transport Speed [Solution] Check that the following parts are properly assembled and/or
High Harness connected, and clean all of the Sensors.
[Relative Parts] Feed Motor 
If the error is not resolved, change the above related part.
Sensor detected a Banknote remaining in path or none present during
an abnormal timing interval.
[Solution] Check that the following parts are properly assembled and/or
Abnormal Timing
Harness connected, and clean all of the Sensors.
Response
[Relative Parts] Intake Sensor, Stack-in Sensor, Store Flap Sensor,
Escrow Sensor, RC Flap Sensor, Validation Sensor 
If the error is not resolved, change the above related part or parts.
The Side Sensor detected a level in-between limits before it passed in
the Banknote through the Guide Sensor, and after it passed the
Banknote through the Side Sensor, and the value was greater than an
acceptable value.
Side Sensor
Problem [Solution] Check that the following parts are properly assembled and/or
Harness connected, and clean all of the Sensors
[Relative Parts] Side Sensor 
If the error is not resolved, change the above related part.
Causes and Solutions
© 2016, JAPAN CASH MACHINE CO., LTD.
A - 5
Section A