Cat (Cable And Antenna Test) Mode - Option 305 - Agilent Technologies FieldFox N9923A User Manual

CAT (Cable and Antenna Test) Mode - Option 305

CAT Mode is typically used to test an entire transmission system, from the
transmitter to the antenna. This process is sometimes referred to as Line
Sweeping.
CAT Mode is similar to NA (Network Analyzer) Mode. Learn more at the FieldFox
Supplemental User"s Guide:
CAT Mode Distance to Fault measurements are discussed on page 42.
In this Chapter
Measurement Selection ......................................... 34
Quick Settings ........................................................ 35
Frequency Range ................................................... 35
Scale Settings ......................................................... 36
Averaging ............................................................... 37
Single/Continuous ................................................. 37
Resolution ............................................................... 37
Sweep Time ............................................................. 38
Output Power ......................................................... 38
Interference Rejection .......................................... 38
Procedures
Return Loss Measurement ................................... 39
1-Port Cable Loss Measurement .......................... 40
2-Port Insertion Loss Measurement ................... 41
Distance to Fault Measurements ......................... 42
See Also
All about Calibration ............................................. 51
Set Markers ............................................................. 76
Use Limit Lines ...................................................... 82
Use Trace Math ...................................................... 84
CAT (Cable and Antenna Test) Mode - Option 305
http://na.tm.agilent.com/fieldfox/help/
33