Draytek Vigor2926L User Manual page 948

E x a m p l
E x a m p
> > ha set -h -4 LAN1 192.168.1.1
% Enable IPv4 Virtual IP on LAN1
% Virtual IP can not be same as router IP (192.168.1.1)!!!
>
T e l n e t C o m m
T e l n e t C o m m
This command can be used to show the settings information about config sync and general
setup.
S y n t a x
S y n t a x
ha show –c
ha show –g
S S y y n n t t a a x x
Parameter
-c
-g
E E x x a a m m p p l
> ha show -g
% High Availability
% Redundancy Method
% Group ID
% Priority ID
% Preempt Mode
% Update DDNS
% Management Interface : LAN1
% Authentication Key
% Syslog
%
% [ Index | Enable | Virtual IP ]
% LAN1
% LAN2
% LAN3
% LAN4
% LAN5
% LAN6
% DMZ
% [ Index | Enable | Virtual IPv6 ]
% LAN1
% LAN2
% LAN3
% LAN4
% LAN5
% LAN6
% DMZ
>
T e l n e t C o m m
T e l n e t C o m m
This command is used to display HA status information.
S y n t a x
S y n t a x
ha status –a [Detail Level]
ha status –m [Detail Level]
S y n t a x
S y n t a x
Parameter
932
e
l e
a n d : h a s h o w
a n d : h a s h o w
D D e e s s c c r r i i p p t t i i o o n n
Description
Show the settings of config sync.
Show the settings of general setup.
l e e
: Disable
: Active-Standby
: 1
: 10
: Enable
: Disable
: draytek
: OFF
On 192.168.1.0
- 0.0.0.0
- 0.0.0.0
- 0.0.0.0
- 0.0.0.0
- 0.0.0.0
- 0.0.0.0
On FE80::200:5EFF:FE00:101
On FE80::200:5EFF:FE00:101
On FE80::200:5EFF:FE00:101
On FE80::200:5EFF:FE00:101
On FE80::200:5EFF:FE00:101
On FE80::200:5EFF:FE00:101
On FE80::200:5EFF:FE00:101
a n d : h a s t a t u s
a n d : h a s t a t u s
D e s c r i p t i o n
D e s c r i p t i o n
Description
Vigor2926 Series User's Guide