Draytek Vigor2926L User Manual page 848

T e l n e t C o m m
T e l n e t C o m m
This command is used to configure TTL settings which will be displayed in DNS Cache table.
S S y y n n t t a a x x
sys dnsCacheTbl [<command><parameter>|...]
S y n t a x
S y n t a x
Parameter
[<command><parameter>|...
]
-l
-s
-v
-t < 0/n >
-c
E x a m p l
E x a m p
> sys dnsCacheTbl -l
%DNS Cache Table List
> sys dnsCacheTbl -t 65
% Set TTL limit: 65 seconds.
% When TTL larger than 65s , delete the DNS entry in the router's DNS cache
tabl
e.
>
T e l n e t C o m m
T e l n e t C o m m
This command is used to configure
S y n t a x
S y n t a x
sys syslog -a <enable> [-<command> <parameter> | ... ]
S y n t a x
S y n t a x
Parameter
[<command><parameter>|...
]
-a <1/0>
-s <1/0>
-i <IP address>
-d <port number>
-u <1/0>
-m <1/0>
-f <1/0>
-v <1/0>
832
a n d : s y s d n s C a c h
a n d : s y s d n s C a c h
D e s c r i p t i o n
D e s c r i p t i o n
Description
The available commands with parameters are listed below.
[...] means that you can type in several commands in one line.
Display DNS IPv4 entry in the DNS cache table.
Display DNS IPv6 entry in the DNS cache table.
Display the TTL limit value in the DNS cache table.
Set the TTL limit value in the DNS cache table.
0- No limit
N – Greater than or equal to 5.
Clear the DNS cache table.
e
l e
a n d : s y s s y s l o g
a n d : s y s s y s l o g
D e s c r i p t i o n
D e s c r i p t i o n
Description
The available commands with parameters are listed below.
[...] means that you can type in several commands in one line.
Enable (1) or disable (0) Syslog Access Setup.
Enable (1) or disable (0) Syslog Save to Syslog Server.
Define the IP address of the Syslog server.
Define the port number (1 ~ 65535) as the destination port.
Enable (1) or disable (0) Syslog Save to USB Disk.
Enable (1) or disable (0) Mail Syslog.
Enable (1) or disable (0) Filewall Log.
Enable (1) or disable (0) VPN Log.
e T b l
e T b l
Vigor2926 Series User's Guide