Draytek Vigor2926L User Manual page 870

ch
mode
voip dsp setDtmfCidlevel –l / voip dsp setDtmfCidlevel –h [value]
voip dsp setDtmfCidlevel –r 0
value
voip dsp setfxoCY
value
voip dsp setfxoringl
value
voip dsp setfxoCid
value
voip dsp cidplusdigit
[1/0] [channel] [value]
854
Set the FAX error correction mode.
ch : range (0 ~ 1)
mode : EC(error correction) ch(x) mode(0) : REDUNDANCY
EC(error correction) ch(x) mode(1) : FEC
"setDtmfCidLevel" is used to configure the signal strength for
transferring to FXS DTMF caller ID.
value - 0 ~ 64
voip dsp setDtmfCidLevel -l [value]
voip dsp setDtmfCidLevel -h [value]
voip dsp setDtmfCidLevel -r 0/1
r - reset low/high DTNF level to default setting. 0 means Disable; 1
means Enable.
Note: This function is supported only by special mode.
It is used to apply FXO country settings.
0: "use system country"
1: "Taiwan"
2: "Germany"
3: "Sweden"
4: "France"
5: "Switzerland"
6: "Holland"
7: "Finland"
8: "Denmark"
9: "UK"
10: "Australia"
12: "Italy"
14: "Red_China"
15: "Singapore"
17: "Spain"
18: "Portugal"
20: "Poland"
21: "Czech"
22: "Hungary"
23: "Slovenia"
25: "Slovakia"
37: "Brasil"
61: "US"
It is used to configure detection ring voltage threshold to apply to
FXO.
Available setting include:
0 : use driver default value
1 : Minimum voltage threshold: 25V
2 : Minimum voltage threshold: 35V
3 : Minimum voltage threshold: 45V
Note: This function is supported only by special mode.
Set FXO detect caller ID type.
It is available only for the model with FXO port.
Set the substitution (0~9) for '+' digit in caller ID.
1 – enable the substitution.
Vigor2926 Series User's Guide