Draytek Vigor2926L User Manual page 809

E x a m p l
E x a m p
> qos setup -m 3 -i 9500 -o 8500 -r 3:20 -u 1 -p 50 -t 1
WAN1 QOS mode is both
Wan 1 is XDSL model ,don,t need to set up
Wan 1 is XDSL model ,don,t need to set up
WAN1 class 3 ratio set to 20
WAN1 udp bandwidth control set to enable
WAN1 udp bandwidth limit ratio set to 50
WAN1 Outbound TCP ACK Prioritizel set to enable
QoS WAN1 set complete; restart QoS
>
T e l n e t C o m m
T e l n e t C o m m
This command allows user to set QoS class.
S y n t a x
S y n t a x
qos class -c [no] –[a|e|d] [no][-<command> <parameter> | ... ]
S S y y n n t t a a x x
Parameter
[<command>
<parameter>|...]
-h
-c <no>
-n <name>
-a
-e <no>
-d <no>
-m <mode>
-l <addr>
-r <addr>
Vigor2926 Series User's Guide
e
l e
a n d : q o s c l a s s
a n d : q o s c l a s s
D D e e s s c c r r i i p p t t i i o o n n
Description
The available commands with parameters are listed below.
[...] means that you can type in several commands in one line.
Type it to display the usage of this command.
Specify the inde number for the class.
Available value for <no> contains 1, 2 and 3. The default setting is
class 1.
It means to type a name for the class.
It means to add rule for specified class.
It means to edit specified rule.
<no>: type the index number for the rule.
It means to delete specified rule.
<no>: type the index number for the rule.
It means to enable or disable the specified rule.
0: disable,
1: enable
Set the local address.
Addr1 – It means Single address. Please specify the IP address
directly, for example, "-l 172.16.3.9".
addr1:addr2 – It means Range address. Please specify the IP
addresses, for example, "-l 172.16.3.9: 172.16.3.50."
addr1:subnet – It means the subnet address with start IP address.
Please type the subnet and the IP address, for example, "-l
172.16.3.9:255.255.0.0".0
any – It means Any address. Simple type "-l" to specify any address
for this command.
Set the remote address.
addr1 – It means Single address. Please specify the IP address
793