Draytek Vigor2926L User Manual page 749

>
T e l n e t C o m m
T e l n e t C o m m
This command allows you to use DHCPv6 protocol to obtain IPv6 address from server.
S y n t a x
S y n t a x
ip6 dhcp client [WAN1|WAN2|iface#] [-<command> <parameter>| ... ]
S S y y n n t t a a x x
Parameter
client
[<command>
<parameter>|...]
-a
-p [IAID]
-n [IAID]
-c [parameter]
-i [parameter]
-e[parameter]
E x a m p l
E x a m p
> ip6 dhcp client WAN2 –p 2008::1
> ip6 dhcp client WAN2 –a
Interface WAN2 has following DHCPv6 client settings:
> ip6 dhcp client WAN2 –n 1023456
> ip6 dhcp client WAN2 –a
Interface WAN2 has following DHCPv6 client settings:
> system reboot
T e l n e t C o m m
T e l n e t C o m m
This command allows you to configure DHCPv6 server.
S S y y n n t t a a x x
ip6 dhcp server [-<command> <parameter>| ... ]
S y n t a x
S y n t a x
Parameter
server
[<command>
<parameter>|...]
Vigor2926 Series User's Guide
a n d : i p 6 d h c p c l i
a n d : i p 6 d h c p c l i
D D e e s s c c r r i i p p t t i i o o n n
e
l e
DHCPv6 client enabled
request IA_PD whose IAID equals to 2008
DHCPv6 client enabled
request IA_NA whose IAID equals to 2008
a n d : i p 6 d h c p s e r
a n d : i p 6 d h c p s e r
D e s c r i p t i o n
D e s c r i p t i o n
Description
It means the dhcp server settings.
The available commands with parameters are listed below.
[...] means that you can type in several commands in one line.
e n t
e n t
Description
It means the dhcp client settings.
The available commands with parameters are listed below.
[...] means that you can type in several commands in one line.
It means to show current DHCPv6 status.
It means to request identity association ID for Prefix Delegation.
It means to request identity association ID for Non-temporary
Address.
It means to send rapid commit to server.
It means to send information request to server.
It means to enable or disable the DHCPv6 client.
1: Enable
0: Disable
v e r
v e r
733