Draytek Vigor2926L User Manual page 900

send
stus
tag
user
wms
E x a m p l
E x a m p
> wan lte band
Access technology : LTE
Access band information : E-UTRA Op Band 3
Interfere with 2.4G WLAN : NO
Active channel: 1725
>wan lte stus
Status: Operational. (Online)
Access Tech: LTE
Band: E-UTRA Op Band 3
ISP: Chunghwa
MCC: 466, MNC: 92, LAC: 65534, Cell ID: 81023501
Max Channel TX Rate: 50000000 bps
Max Channel RX Rate: 100000000 bps
IMEI: 356318040749422
IMSI: 466924200859808
RSSI: -61 dBm
Unread SMS: 4
SMSC address: +886932400821
884
[...] means that you can type in several commands in one line.
-a <0/1>: Enable or disable Access Control List. (0: disable 1:
enable)
-c <0/1>: Set whether to reply with MAC address. (0: no 1: yes)
-e <0/1>: Enable or disable Reboot on SMS Message function. (0:
disable 1: enable)
-f <0/1>: Set whether to reply with WAN1 IP address. (0: no 1: yes)
-g <0/1>: Set whether to reply with WAN2 IP address. (0: no 1: yes)
-h <0/1>: Set whether to reply with LTE WAN IP address. (0: no 1:
yes)
-i <0/1>: Set whether to reply with WAN4 IP address. (0: no 1: yes)
-j <0/1>: Set whether to reply with WAN1 data usage. (0: no 1: yes)
-k <0/1>: Set whether to reply with WAN2 data usage. (0: no 1: yes)
-l <0/1>: Set whether to reply with LTE WAN data usage. (0: no 1:
yes)
-m <0/1>: Set whether to reply with WAN4 data usage. (0: no 1: yes)
-n <0/1>: Set whether to reply with Router name. (0: no 1: yes)
-p <password>: Set the Password / PIN. This setting is necessary if
this function is enabled.
-u <0/1>: Set whether to reply with Router system uptime. (0: no 1:
yes)
-v <0/1>: Set whether to reply with Router firmware version. (0: no
1: yes)
-x <number>: Set the first phone number in Access Control List.
-y <number>: Set the second phone number in Access Control List.
-z <number>: Set the third phone number in Access Control List.
Send an SMS message to the specified phone number through the
LTE SIM card.
Display status of LTE connection.
Set an SMS in the LTE SIM card as read state by specifying the index
number. Use "all" to set all SMS as read state.
Set the UserName of LTE WAN.
This command is for RD debug only. We use it to test new USB
modems. Please don't use it without our advice.
e
l e
Vigor2926 Series User's Guide