Ii-1-1-1 Wan1/Wan2 With Ethernet - Draytek Vigor2926L User Manual

Index
Enable
Physical Mode / Type
Line Speed(Kbps)
DownLink/UpLink
Active Mode
Info
After finished the above settings, click OK to save the settings.
I I - 1 - 1 - 1 W
I I - 1 - 1 - 1 W
WAN1/WAN2 is fixed with physical mode of Ethernet.
Vigor2926 Series User's Guide
bandwidth for your WAN interface, please choose the setting
of According to Line Speed. Otherwise, please choose Auto
Weight to let the router reach the best load balance.
IP Based - The same source / destination IP pair will select
the same WAN interface as policy. It is the default setting.
Sesseion Based- All of the WAN interfaces will be used (as
out-going WAN) for passing through new sessions to get
better transmission speed. Though good speed test result for
throughput might be reached; however, some web site may
not open smoothly, especially the site need authentication,
e.g., FTP.
If you have no strong demand about speed test result, keep
default settings as IP based.
Click the WAN interface link under Index to access into the
WAN configuration page.
V means such WAN interface is enabled and ready to be used.
Display the physical mode and physical type of such WAN
interface.
Display the downstream and upstream rate of such WAN
interface.
Display whether such WAN interface is Active device or
backup device.
In default, each WAN port is enabled.
A N 1 / W A N 2 w i t h E t
A N 1 / W A N 2 w i t h E t
h e r n e t
h e r n e t
55