Electrical Parts And Motors - Brother NX600 Service Manual

Main unit
1
Power supply unit F removal
1. Unplug all of the connectors on the main PCB assy. 1.
2. Remove the main motor connector 2.
3. Disconnect the inlet assy. connector 3.
4. Remove the screws 1 (three), and remove power supply unit F 4.
Start movie clip (CD-ROM version only)
2
Assy. pin jack F removal
1. Remove the nut 1, and remove the assy. pin jack F 2.
3
Wire assy. removal
1. Remove retaining ring E3.
2. Loosen nut M8 1, and remove the wire assy. 2.
2 - 10

Electrical parts and motors

1
4 2
1
2
2 1
Retaining ring E3
3
1