Main unit
11
Base plate attachment
1. Attach the base plate assembly 1 to the arm bed using the screws 1
(three).
*Key point
• Pull the power cord approximately 5 cm out of the cord reel
assembly.
Start movie clip (CD-ROM version only)
1
12
Wire assy. and knee lifter assy. attachment
1. Attach the fitting 1 on the end of the wire assy. (side with two M8 nuts on
it) to the wire holder 2 on the knee lifter assy., and hand tighten the M8
nut 3 on the lower side.
(Fully tighten after 4 - 21 "Knee lifter adjustment.")
2. Attach the hook 4 on the end of the wire assy. to the knee lifter assy. shaft,
and attach retaining ring E3.
13
Power supply unit F attachment
1. Attach power supply unit F 1 to the arm bed using the screws 1 (three).
2. Attach the connector 2 for the inlet assy. to the power supply unit F.
Start movie clip (CD-ROM version only)
1
Electrical parts and motors
Taptite, Bind S
M4X10
1.47 – 1.96 N·m
Color; Gold
Screw, Pan (S/P washer)
M4X14
0.78 – 1.18 N·m
Color; Silver
Torque
1
2
3
4
Torque
1
1
1
3
1
3
2
3 - 29