Table of Contents
Advertisement
Names of Machine Parts
1 GETTING READY
Chapter
Names of Machine Parts
Main parts
a Thread guide
b Spool pin
c Bobbin winder
d Grips (2 locations)
Use the grips to transport the machine. (page 11)
e Embroidery carriage
f Thread tension dial
g Operation buttons and LED (page 10, page 33)
h Handwheel
Turn the handwheel toward the thread tension dial to raise
and lower the needle.
i Needle threader lever
j Thread cutter
k Power supply jack
l Main power switch
Press the right side of the switch ("I") to turn it on, and the
left side ("O") to turn it off.
m Air vents (2 locations)
The air vents allow the air surrounding the motor to
circulate. Do not cover the air vents while the machine is
being used.
Needle and presser foot section
a Needle bar thread guide
b Needle clamp screw
c Presser foot
The presser foot helps control fabric flexibility for better
stitch consistency.
d Needle plate
e Needle plate cover
f Bobbin cover
10
m
Operation buttons and LED
a Bluetooth button
Hold down to pair the machine and the app via Bluetooth.
(page 13)
The LED beside the button changes its lighting depending
on the connection status between the machine and the app.
b Accept button
Press this button according to the instructions of the app
when LED blinking.
Hold down this button to enter the Needle/thread exchange
mode. (page 21).
c Thread cutter button
Press to cut the upper thread and the bobbin thread when
embroidering is finished.
d Threading position button
Press to move the needle position (the height) appropriate
for threading.
e "Start/Stop" button
Press to start or stop embroidering. The color and lighting
condition of the LED change depending on the status of the
machine.
For details on the LED lighting conditions, refer to "LED
indications" on page 33.
Embroidery frame (Magnetic frame)
a Upper frame
b Base frame
c Marks for [Camera scan] function
Advertisement
Table of Contents
