Chapter 1 Getting Ready; Names Of Machine Parts - Brother 882-W83 Operation Manual

1
Chapter
Note
• Be sure to install the latest software.
Refer to "UPDATING YOUR MACHINE'S
SOFTWARE" on page 121.

NAMES OF MACHINE PARTS

 Main Parts
a
1 Top cover
2 Pretension disk (page 23)
3 Thread guide for bobbin winding (page 23)
4 Spool pin (page 24)
5 Spool cap (page 22)
6 Supplemental spool pin (page 22)
7 Bobbin winder (page 22)
8 LCD (liquid crystal display) (page 12)
9 Speaker
0 Operation buttons (page 10)
A Embroidery unit (page 32)
B Thread cutter (page 28)
C Thread guide plate (page 24)
D Connector for the presser foot (page 111)
E Handle
Carry the machine by its handle when transporting the
machine.
GETTING READY
NAMES OF MACHINE PARTS
F Presser foot lever
You cannot use the presser foot lever after the presser foot has
been raised using (Presser foot lifter button).
G Air vent
The air vent allows the air surrounding the motor to circulate.
Do not cover the air vent while the machine is being used.
H Main power switch (page 10)
I Power cord receptacle (page 11)
J USB port for mouse (page 21)
K USB port
L Handwheel
Turn the handwheel toward you (counterclockwise) to raise and
lower the needle.
 Needle and Presser Foot Section
a
1 Screw for embroidery foot (page 111)
2 Embroidery foot
The embroidery foot helps control fabric flexibility for better
stitch consistency.
3 Bobbin cover (page 25)
4 Needle plate cover (page 25)
5 Needle plate (page 110)
6 Needle bar thread guide (page 27)
7 Needle clamp screw (page 29)
1
9