Grease Applications - Brother NX600 Service Manual

Modules
10

Grease applications

1. Apply a small amount of Epnoc Grease AP to the all of the operating
surfaces 1 of the idle gear assy. and C pulse motor gear.
2. Apply a small amount of Epnoc Grease AP to the all of the operating
surfaces 2 of the thread cutter lever gear and idle gear assy.
3. Apply a small amount of Epnoc Grease AP to the entire operating surface
3 of the thread cutter lever thread hook pin A.
Apply Epnoc Grease AP to the entire operating surfaces
of idle gears A and B and the CPM gear.
Apply Epnoc Grease AP to the to the operating
surfaces of the thread cutter lever gear and idle gears
A and B
Apply Epnoc Grease AP to the operating surface of thread
hook pin A
11
Thread cutter frame assy. attachment
1. Attach a polyester slider 1 to thread hook pin A 2.
2. Attach the thread cutter frame assy. 3 and collars 4 (two) to the motor
holder assy. 5 using the screws 1 (two).
*Key point
• Align the thread cutter lever shaft 6 and thread cutter frame
hole 7, and the thread hook pin A and thread cutter lever hole
8.
Start movie clip (CD-ROM version only)
1
12
CPM lead processing
1. Attach the CPM leads to the motor holder 2 using a band 1.
Start movie clip (CD-ROM version only)
3 - 78
Thread cutter module
Screw, Bind
M4X20
Color; Silver
2
Small amount
Small amount
Small amount
1
Torque
1.18 – 1.57 N·m
3
6 2 7
8 1
3 1
4 5
2
1