Assembling The Thread Cutter Lever Assy - Brother NX600 Service Manual

Modules
3

Assembling the thread cutter lever assy.

1. Attach the thread cutter lever gear 1 to the thread cutter lever 2 using the
screw 1.
Start movie clip (CD-ROM version only)
1
4
Thread cutter lever assy. attachment
1. Apply a small amount of Epnoc Grease AP to the thread cutter lever shaft.
2. Attach the thread cutter lever assy. 1 to the thread cutter lever shaft.
*Key point
• Align the thread cutter lever 1 match mark 2 with the idle
gear assy. match mark 3.
Apply a small amount of Epnoc Grease AP to the
thread cutter lever shaft.
Start movie clip (CD-ROM version only)
5
Rubber and spacer attachment
1. Attach the rubber 1 to the thread cutter frame 2 shaft, and attach
retaining ring E2.
2. Attach the spacer 3 to the thread cutter frame 2.
Start movie clip (CD-ROM version only)
3 - 76
Thread cutter module
Screw, Pan (S/P washer)
M3X6DA
Color; Gold
Torque
0.78 – 1.18 N·m
Small amount
2
1
1 3
2
Retaining ring E2
2
3
1
1