F Gear Teeth Alignment - Brother NX600 Service Manual

Modules
21

F gear teeth alignment

1. Apply a small amount of Epnoc Grease AP to the feed adjuster assy. F gear
1.
2. Turn the F pulse motor gear clockwise until the stopper 2 on it touches the
bushing supporter assy. shaft 3.
3. Turn the feed adjuster assy. 4 until it touches 5 the F pulse motor gear.
*Key point
• Once the feed adjuster assy. 4 and F pulse motor gear are
touching, hold the F pulse motor gear with your finger 6 so
that it does not turn.
4. Push the feed adjuster assy. 4 until it and the F gear 7 have their gears
aligned 8.
5. With the gears 8 aligned, push them down, and mesh the feed adjuster
assy. 4 and F pulse motor gears.
*Key point
• Check that the feed adjuster assy. 4 gear match mark 9 and
the F pulse motor gear match mark ; are together.
Apply Epnoc Grease AP to the all of the teeth on the
feed adjuster assy. F gear
Start movie clip (CD-ROM version only)
3 - 72
Feed module
1
4
Small amount
3 2
7 5
Gear is offset
8
Gear aligned
9,;
6
6