Thread Cutter Module; C Pulse Motor Attachment - Brother NX600 Service Manual

Modules
1

C pulse motor attachment.

1. Attach the C pulse motor (ZPMM35SP-9N) 1 to the motor holder assy. 2
using the screws 1 (two).
2. Lubricate the C pulse motor 1 bearing with 1 – 2 drops of
turbine oil # 100.
Lubricate the CPM bearing with turbine oil #100.
Start movie clip (CD-ROM version only)
1
2
Idle gears A and B attachment
1. Apply a small amount of Epnoc Grease AP to the idle gear shaft 1.
2. Attach idle gear A 2, the spring 3 and idle gear B 4 to the idle gear shaft
1, and attach retaining ring E2.
*Key point
• Insert the spring 3 into the small holes 5 in idle gear A 2
and idle gear B 4, and turn idle gear A 2 clockwise until the
large holes 6 in idle gear A 2 and idle gear B 4 overlap 7.
• With the large holes 6 aligned 7, align the match mark 8 on
the idle gear assy. and the match mark 9 on the C pulse
motor gear, and attach the idle gear assy. to 1.
Apply Epnoc Grease AP to the lever guide shaft
Start movie clip (CD-ROM version only)

Thread cutter module

Screw, Bind
M3X4
0.78 – 1.18 N·m
Color; Silver
Small amount
1 – 2 drops
Torque
2
2
3
7
1
1
6
5 4
1
9 8
Retaining ring E2
3 - 75