Face Plate Assembly - Brother NX600 Service Manual

Main unit
16

Face plate assembly

1. Attach the needle thread lever shaft 1, needle thread lever 2 and rubber
washer 3 to the face plate.
2. Attach to the presser plate 4.
S01
3. Attach the presser plate 4 to the face plate using the screw 1.
4. Attach the screw 2 and a washer.
5. Attach the that was attached to the presser plate 4 in 2. to the needle
S01
thread lever 2.
6. Attach the retaining ring, CS5 and the NT lower thread cutter 5 to the face
plate.
7. Attach the needle thread lever knob 6.
1
2
S01
17
Face plate assy. attachment
1. Align and attach the hole 1 in the center on the inside of the face plate to
the shaft 2 on the needle-presser module.
2. Secure the face plate assy. to the arm bed with the screw 1.
Start movie clip (CD-ROM version only)
1
18
Accessory table assembly and attachment
1. Attach the accessory table door to the accessory table 1.
2. Attach the accessory table 1 to the main unit.
3 - 40
Main parts
Taptite, Pan B
M3X6
Color; Silver
Taptite, Bind B
M3X10
Color; Gold
23
THREAD THROUGH LEVER SPRING
4
Screw, Pan (S/P washer)
M4X14
Color; Silver
Torque
0.57 – 1.78 N·m
Torque
0.57 – 0.78 N·m
138260***
Torque
0.78 – 1.18 N·m
S01
3 4 1
1 2 2 5
1
2
1
2
1