Front Cover Attachment - Brother NX600 Service Manual

Main unit
11

Front cover attachment

1. Hand start the screw 1.
2. Attach the flat cable 1 from the operation F3 PCB assy. to CN7 on the
main PCB assy.
3. Attach the front cover.
*Key point
• Attach starting with the bobbin winder cover 2.
• Attach the lower hooks 3 (two).
• Slide to the left, and attach the center hook 4.
4. Fully tighten hand started the screw 1 in the thread guard assembly.
5. Attach the screws 2 (two).
6. Attach the screw 3.
NOTE •Attach so that the flat cable is not shifted to the left or right.
Start movie clip (CD-ROM version only)
1
2
3
12
Front thread guide cover attachment
1. Attach the front thread guide cover 1 using the screw 1.
Start movie clip (CD-ROM version only)
1
3 - 38
Main parts
Screw, Pan (S/P washer)
M3X6F
Color; Silver
Taptite, Cup B
M4X14
Color; Silver
Taptite, Cup B
M4X20
Color; Silver
Screw, Bind
M3X4
Color; Silver
1
Torque
0.57 – 0.78 N·m
Torque
0.78 – 1.18 N·m
Torque
0.78 – 1.18 N·m
Torque
0.78 – 1.18 N·m
2
4 2
3
3
1 1
1