Brother NX600 Service Manual page 28

Main unit
13
Front cover disassembly (SV keytop removal)
1. Remove the SV keytop 1.
*Key point
• Insert a standard screwdriver between 1 and 2, and push
the SV keytop 1 out on the front side.
2. Remove the SV joint plate 2.
Start movie clip (CD-ROM version only)
14
Rear cover removal
1. Lower the presser lever, and pull the cord in the cord real assembly out
approximately 5 cm.
2. Remove the screw 1.
3. Undo the hooked places 1 and remove the rear cover.
Start movie clip (CD-ROM version only)
15
Handle removal
1. Remove the screws 1 (two), and remove the handle 1.
2. Remove the retaining rings E4 (two) from the handle shafts, and remove
the handle 1, the handle shafts (two ) and the polyester sliders (two) from
the handle holder.
2 - 8
Main parts
*Top view
2
1
1 1
Retaining ring E4
1
1
1