Main Unit Main Parts - Brother NX600 Service Manual

Main unit
1
Accessory table removal
1. Remove accessory table 1.
2. Remove the accessory table door from the accessory table 1.
2
Top cover removal
1. Remove top cover 1.
*Key point
• Push the attached part toward the inside and remove.
3
Face plate removal and disassembly
1. Remove the screw 1, and remove the face plate 1.
2. Remove the needle thread lever knob 2.
3. Remove the CS5 retaining ring 3 and remove the NT lower thread cutter
4.
4. Remove the screw 2 and the screw 3, and remove the shaft presser plate
and washer 5.
5. Remove .
S01
6. Remove the needle thread lever shaft 6.
7. Remove the needle thread lever 7 from the needle thread lever shaft 6,
and remove the rubber washer.
Start movie clip (CD-ROM version only)
Main parts
1
1
1
1
S01
5 2 7
6 3 4 3
2 - 3
2