AudioCodes Mediant 500L User Manual page 614

•
Endpoints per Trunk Group: Open the Trunk Group Settings table (see
'Configuring Trunk Group Settings' on page 503), and then for the required Trunk
Group ID, configure the 'Registration Mode' parameter to Per Endpoint
(TrunkGroupSettings_RegistrationMode).
2. Open the Authentication table (Setup menu > Signaling & Media tab > Gateway
folder > Analog Gateway > Authentication).
3. Select the row corresponding to the port that you want to configure, and then click
Edit; the following dialog box appears:
4. Configure authentication per port according to the parameters described in the table
below.
5. Click Apply.
Table 28-1: Authentication Table Parameter Descriptions
Parameter
General
Index
[Authentication_Index]
Module
port-type
[Authentication_Module]
Port
port
[Authentication_Port]
Port Type
[Authentication_PortType]
Credentials
User Name
user-name
[Authentication_UserId]
Password
password
[Authentication_UserPassword]
User's Manual
Figure 28-5: Authentication Table - Edit Dialog Box
(Read-only) Displays the index number of the table row.
(Read-only) Displays the module number on which the port is
located.
(Read-only) Displays the port number.
(Read-only) Displays the port type (FXS or FXO).
Defines the user name used for authenticating the port.
Defines the password used for authenticating the port.
Mediant 500L Gateway & E-SBC
Description
614 Document #: LTRT-10532