AudioCodes Mediant 500L User Manual page 385

User's Manual
Parameter
Min. Active Servers for Load
Balancing
min-active-serv-lb
[ProxySet_MinActiveServersLB]
Advanced
Classification Input
classification-input
[ProxySet_ClassificationInput]
Version 7.2
percentage of the requests according to its' assigned weight. A
single FQDN should be configured as a proxy IP address.
Random Weights Load Balancing is not used in the following
scenarios:

More than one IP address has been configured for the
Proxy Set.

The proxy address is not configured as an FQDN (only IP
address).

SRV is disabled (see the DNSQueryType parameter).

The SRV response includes several records with a different
Priority value.
Defines the minimum number of proxies in the Proxy Set that must
be online for the device to consider the Proxy Set as online, when
proxy load balancing is used.
The valid value is 1 to 15. The default is 1.
Note: The parameter is applicable only if proxy load balancing is
enabled (see the 'Proxy Load Balancing Method' parameter,
above).
Defines how the device classifies incoming IP calls to the Proxy
Set.

[0] IP Address Only = (Default) Classifies calls to the Proxy Set
according to IP address only.

[1] IP Address, Port & Transport Type = Classifies calls to the
Proxy Set according to IP address, port, and transport type.
Note:

The parameter is applicable only if the IP Groups table's
parameter, 'Classify by Proxy Set' is set to Enable (see
Configuring IP Groups on page 363).

The parameter is applicable only to the SBC application.

If more than one Proxy Set is configured with the same IP
address and associated with the same SIP Interface, the device
may classify and route the SIP dialog to an incorrect IP Group.
In such a scenario, a warning is generated in the Syslog
message. However, if some Proxy Sets are configured with the
same IP address but different ports (e.g., 10.1.1.1:5060 and
10.1.1.1:5070) and the parameter is configured to IP Address,
Port & Transport Type, classification to the correct IP Group is
achieved. Therefore, when classification is by Proxy Set, pay
attention to the configured IP addresses and this parameter.
When more than one Proxy Set is configured with the same IP
address, the device selects the matching Proxy Set in the
following order:

Selects the Proxy Set whose IP address, port, and transport
type match the source of the incoming dialog (regardless of
the settings of this parameter).

If no match is found for above, it selects the Proxy Set
whose IP address and transport type match the source of
the incoming dialog (if the parameter is configured to IP
Address Only).

If no match is found for above, it selects the Proxy Set
whose IP address match the source of the incoming dialog
385
17. Control Network
Description
Mediant 500L Gateway & E-SBC