AudioCodes Mediant 500L User Manual page 437

User's Manual
and the last coder, the lowest priority. For more information, see ''Prioritizing Coder List in
SDP Offer'' on page 653.
Note:
application.
The following procedure describes how to configure Allowed Video Coders Groups through
the Web interface. You can also configure it through ini file (AllowedVideoCodersGroups
and AllowedVideoCoders) or CLI (configure voip > coders-and-profiles allowed-video-
coders-groups; configure voip > coders-and-profiles allowed-video-coders <group
index/coder index>).

To configure an Allowed Video Coders Group:
1. Open the Allowed Video Coders Groups table (Setup menu > Signaling & Media tab
> Coders & Profiles folder > Allowed Video Coders Groups).
2. Click New; the following dialog box appears:
Figure 20-5: Allowed Video Coders Groups Table - Add Dialog Box
3. Configure a name for the Allowed Video Coders Group according to the parameters
described in the table below.
4. Click Apply.
5. Select the new row that you configured, and then click the Allowed Video Coders link
located below the table; the Allowed Video Coders table opens.
6. Click New; the following dialog box appears:
Figure 20-6: Allowed Video Coders Table - Add Dialog Box
7. Configure coders for the Allowed Video Coders Group according to the parameters
described in the table below.
8. Click Apply.
Version 7.2
The Allowed Audio Coders Groups table is applicable only to the SBC
437 Mediant 500L Gateway & E-SBC
20. Coders and Profiles