AudioCodes Mediant 500L User Manual page 407

User's Manual

Correct:
•
Single rule:
Condition: ldap.found !exists
•
Set of rules:
Condition: ldap.found exists
Condition: <leave it blank>
Note:
rules, they revert to their original values if the device moves to the next routing rule.
The following procedure describes how to configure Call Setup Rules through the Web
interface. You can also configure it through ini file (CallSetupRules) or CLI (configure voip >
message call-setup-rules).

To configure a Call Setup rule:
1. Open the Call Setup Rules table (Setup menu > Signaling & Media tab > SIP
Definitions folder > Call Setup Rules).
2. Click New; the following dialog box appears:
3. Configure a Call Setup rule according to the parameters described in the table below.
4. Click Apply, and then save your settings to flash memory.
Parameter
General
Index
[CallSetupRules_Index]
Rules Set ID
rules-set-id
Version 7.2
If the source and/or destination numbers are manipulated by the Call Setup
Figure 18-1: Call Setup Rules Table - Add Dialog Box
Table 18-2: Call Setup Rules Parameter Descriptions
Defines an index number for the new table record.
Note: Each rule must be configured with a unique index.
Defines a Set ID for the rule. You can define the same Set ID
for multiple rules to create a group of rules. You can configure
up to 10 Set IDs, where each Set ID can include up to 10 rules.
Action Type: Exit
Action Type: Exit
Action Type: Exit
Description
407 Mediant 500L Gateway & E-SBC
18. SIP Definitions
Action Value: False
Action Value: True
Action Value: False