Saving Configuration - AudioCodes Mediant 500L User Manual

42.4

Saving Configuration

When you configure parameters and tables in the Web interface and then click the Apply
button on the pages in which the configurations are done, changes are saved to the
device's volatile memory (RAM). These changes revert to their previous settings if the
device subsequently resets (hardware or software) or powers down. Therefore, to ensure
that your configuration changes are retained, you must save them to the device's non-
volatile memory (i.e., flash memory).
To save your settings to flash, click the Save button located on the toolbar. To remind you
to save your settings to flash, the Save button is displayed with a red border, as shown
below:
To save configuration to flash through CLI, use the following command:
# write
Note: Saving configuration to flash may disrupt current traffic on the device. To avoid
this, disable all new traffic before saving, by performing a graceful lock (see ''Locking
and Unlocking the Device'' on page 781).
User's Manual
Figure 42-4: Saving Configuration to Flash
782
Mediant 500L Gateway & E-SBC
Document #: LTRT-10532