AudioCodes Mediant 500L User Manual page 285

User's Manual
Parameter
Persistent Connection
http-persistent-
connection
[HTTPRemoteServices_Persist
entConnection]
Number of Sockets
http-num-sockets
[HTTPRemoteServices_NumOf
Sockets]
Login
Login Needed
http-login-needed
[HTTPRemoteServices_LoginN
eeded]
Username
rest-user-name
[HTTPRemoteServices_AuthUs
erName]
Password
rest-password
[HTTPRemoteServices_AuthPa
ssword]
Security
TLS Context
rest-tls-context
[HTTPRemoteServices_TLSCo
ntext]
Verify Certificate
rest-verify-
Version 7.2
configured hosts. Every consecutive message is sent to the next
available host.

[1] Sticky Primary = Device always attempts to send traffic to
the first (primary) host. If the host does not respond, the device
sends the traffic to the next available host. If the primary host
becomes available again, the device sends the traffic to the
primary host.

[2] Sticky Next = Similar to Sticky Primary, but if the primary
host does not respond, the device sends the traffic to the next
available host and continues sending traffic to this host even if
the primary host becomes available again.
Defines whether the HTTP connection with the host remains open
or is only opened per request.

[0] Disable = Connection is not persistent and closes when the
device detects inactivity. The device uses HTTP keep-alive
messages to detect inactivity.

[1] Enable = (Default) Connection remains open (persistent)
even during inactivity. The device uses HTTP keep-alive / HTTP
persistent connection messages to keep the connection open.
Defines how many sockets (connection) are established per remote
host.
The valid value is 1 to 10. The default is 1.
Enables the use of proprietary REST API Login and Logout
commands for connecting to the remote host. The commands
verify specific information (e.g., software version) before allowing
connectivity with the device.

[0] Disable = Commands are not used.

[1] Enable (default)
Defines the username for HTTP authentication.
The valid value is a string of up to 80 characters. The default is
"user".
Defines the password for HTTP authentication.
The valid value is a string of up to 80 characters. The default is
"password".
Assigns a TLS Context for connection with the remote host.
By default, no value is defined.
To configure TLS Contexts, see ''Configuring TLS Certificate
Contexts'' on page 113.
Note: The parameter is applicable only if the connection is HTTPS.
Enables certificate verification when connection with the host is
based on HTTPS.
285
Description
Mediant 500L Gateway & E-SBC
15. Services