AudioCodes Mediant 500L User Manual page 364


Quality of Experience Profile: Call quality monitoring based on thresholds for voice
metrics (e.g., MOS) can be applied per IP Group. For example, if MOS is considered
poor, calls belonging to this IP Group can be rejected. To configure Quality of
Experience Profiles, see ''Configuring Quality of Experience Profiles'' on page 325.

Bandwidth Profile: Bandwidth utilization thresholds can be applied per IP Group. For
example, if bandwidth thresholds are crossed, the device can reject any new calls on
this IP Group. To configure Bandwidth Profiles, see ''Configuring Bandwidth Profiles''
on page 330.
Note:
•
For the Gateway application: IP Group ID 0 cannot be associated with Proxy Set
ID 0.
•
If you delete an IP Group or modify the 'Type' or 'SRD' parameters, the device
immediately terminates currently active calls that are associated with the IP
Group. In addition, all users belonging to the IP Group are removed from the
device's users database.
The following procedure describes how to configure IP Groups through the Web interface.
You can also configure it through ini file (IPGroup) or CLI (configure voip > ip-group).

To configure an IP Group:
1. Open the IP Groups table (Setup menu > Signaling & Media tab > Core Entities
folder > IP Groups).
2. Click New; the following dialog box appears:
3. Configure an IP Group according to to the parameters described in the table below.
4. Click Apply.
Table 17-6: IP Groups Table Parameter Descriptions
Parameter
SRD
srd-name
User's Manual
Assigns an SRD to the IP Group.
If only one SRD is configured in the SRDs table, the SRD is assigned by
default. If multiple SRDs are configured in the SRDs table, no value is
364
Mediant 500L Gateway & E-SBC
Description
Document #: LTRT-10532