Https Parameters; Srtp Parameters - AudioCodes Mediant 500L User Manual

Parameter

69.4.2 HTTPS Parameters

The Secure Hypertext Transport Protocol (HTTPS) parameters are described in the table
below.
Parameter
Secured Web Connection
(HTTPS)
configure system > web >
secured-connection
[HTTPSOnly]
configure system > web > https-
port
[HTTPSPort]
Require Client Certificates for
HTTPS connection
configure system > web > req-
client-cert
[HTTPSRequireClientCertificate]

69.4.3 SRTP Parameters

The Secure Real-Time Transport Protocol (SRTP) parameters are described in the table
below.
Parameter
Media Security
configure voip > media
security > media-security-
enable
[EnableMediaSecurity]
User's Manual
The valid range is 0 to 255. The default is 10.
Table 69-23: HTTPS Parameters
Determines the protocol used to access the Web interface.

[0] HTTP and HTTPS (default).

[1] HTTPs Only = Unencrypted HTTP packets are blocked.
Note: For the parameter to take effect, a device reset is required.
Defines the local Secured HTTPS port of the device. The
parameter allows secure remote device Web management from
the LAN. To enable secure Web management from the LAN,
configure the desired port.
The valid range is 1 to 65535 (other restrictions may apply within
this range). The default port is 443.
Note: For the parameter to take effect, a device reset is required.
Enables the requirement of client certificates for HTTPS
connection.

[0] Disable = (Default) Client certificates are not required.

[1] Enable = Client certificates are required. The client
certificate must be preloaded to the device and its matching
private key must be installed on the managing PC. Time and
date must be correctly set on the device for the client certificate
to be verified.
Note:

For the parameter to take effect, a device reset is required.

For a description on implementing client certificates, see ''TLS
for Remote Device Management'' on page 126.
Table 69-24: SRTP Parameters
Enables Secure Real-Time Transport Protocol (SRTP).

[0] Disable (default)

[1] Enable
Note:

For the parameter to take effect, a device reset is required.
1042
Mediant 500L Gateway & E-SBC
Description
Description
Description
Document #: LTRT-10532