AudioCodes Mediant 500L User Manual page 1013

User's Manual
Parameter
IP Address
ip-address
[SNMPManagerTableIP_x]
Trap Port
port
[SNMPManagerTrapPort_x]
Trap Enable
send-trap
[SNMPManagerTrapSendingEnable_
x]
Trap User
trap-user
[SNMPManagerTrapUser_x]
Trap Manager Host Name
manager-host-name
[SNMPTrapManagerHostName]
Activity Trap
configure troubleshoot > activity-trap
[EnableActivityTrap]
SNMP Community String Parameters
Read Only Community Strings
configure system > snmp settings >
ro-community-string
[SNMPReadOnlyCommunityString_x]
Read/Write Community Strings
configure system > snmp settings >
rw-community-string
[SNMPReadWriteCommunityString_x
]
Trap Community String
configure system > snmp trap >
community-string
[SNMPTrapCommunityString]
Version 7.2
69. Configuration Parameters Reference

[0] (Check box cleared) = Disabled (default)

[1] (Check box selected) = Enabled
Defines the IP address of the remote host used as an SNMP
Manager. The device sends SNMP traps to this IP address.
Enter the IP address in dotted-decimal notation, e.g.,
108.10.1.255.
Defines the port number of the remote SNMP Manager. The
device sends SNMP traps to this port.
The valid SNMP trap port range is 100 to 4000. The default
port is 162.
Enables the sending of traps to the corresponding SNMP
manager.

[0] Disable = Sending is disabled.

[1] Enable = (Default) Sending is enabled.
Defines the SNMPv3 USM user or SNMPv2 user to associate
with the trap destination. This determines the trap format,
authentication level, and encryption level. By default, it is
associated with the SNMPv2 user (SNMP trap community
string).
The valid value is a string.
Defines an FQDN of the remote host used as an SNMP
manager to receive traps sent by the device. The device
sends the traps to the DNS-resolved IP address.
The valid range is a string of up to 99 characters.
For more information, see ''Configuring an SNMP Trap
Destination with FQDN'' on page 100.
Enables the device to send an SNMP trap to notify of Web
user activities in the Web interface. The activities to report are
configured by the ActivityListToLog parameter.

[0] Disable (default)

[1] Enable
Defines a read-only SNMP community string. Up to five read-
only community strings can be configured.
For more information, see Configuring SNMP Community
Strings on page 97.
Defines a read-write SNMP community string. Up to five read-
write community strings can be configured.
For more information, see Configuring SNMP Community
Strings on page 97.
Defines the community string for SNMP traps.
For more information, see Configuring SNMP Community
Strings on page 97.
1013
Description
Mediant 500L Gateway & E-SBC