AudioCodes Mediant 500L User Manual page 1078

Parameter
TGRP Routing Precedence
configure voip > gateway
routing settings > tgrp-
routing-prec
[TGRProutingPrecedence]
configure voip > sip-
definition settings > use-dtg
[UseBroadsoftDTG]
User's Manual
context=dsn.mil" in the Contact header.
- If ISDN Setup does not contain an Off Hook Indicator IE and
the Bearer Capability IE contains "Unrestricted 64k", the
outgoing INVITE includes "tgrp=ccdata;trunk-context=dsn.mil".
If the Bearer Capability IE contains "Speech", the INVITE in this
case does not contain tgrp and trunk-context parameters.

[4] Hotline Extended = Interworks the ISDN Setup message's
hotline "OffHook Indicator" Information Element (IE) to SIP INVITE's
Request-URI and Contact headers. (Note: For IP-to-ISDN calls, the
device handles the call as described in option [3].)

The device interworks ISDN Setup with an Off Hook Indicator of
"Voice" to SIP INVITE Request-URI and Contact header with
"tgrp=hotline;trunk-context=dsn.mil".

The device interworks ISDN Setup with an Off Hook indicator of
"Data" to SIP INVITE Request-URI and Contact header with
"tgrp=hotline-ccdata;trunk-context=dsn.mil".

If ISDN Setup does not contain an Off Hook Indicator IE and
the Bearer Capability IE contains "Unrestricted 64k", the
outgoing INVITE Request-URI and Contact header includes
"tgrp=ccdata;trunk-context=dsn.mil". If the Bearer Capability IE
contains "Speech", the INVITE in this case does not contain
tgrp and trunk-context parameters.
Note: IP-to-Tel configuration (using the PSTNPrefix parameter)
overrides the 'tgrp' parameter in incoming INVITE messages.
Determines the precedence method for routing IP-to-Tel calls -
according to the IP-to-Tel Routing table or according to the SIP 'tgrp'
parameter.

[0] = (Default) IP-to-Tel routing is determined by the IP-to-Tel
Routing table (PSTNPrefix parameter). If a matching rule is not
found in this table, the device uses the Trunk Group parameters for
routing the call.

[1] = The device first places precedence on the 'tgrp' parameter for
IP-to-Tel routing. If the received INVITE Request-URI does not
contain the 'tgrp' parameter or if the Trunk Group number is not
defined, the IP-to-Tel Routing table is used for routing the call.
Below is an example of an INVITE Request-URI with the 'tgrp'
parameter, indicating that the IP call should be routed to Trunk Group
7:
INVITE sip:200;tgrp=7;trunk-
context=example.com@10.33.2.68;user=phone SIP/2.0
Note:

For enabling routing based on the 'tgrp' parameter, the UseSIPTgrp
parameter must be set to 2.

For IP-to-Tel routing based on the 'dtg' parameter (instead of the
'tgrp' parameter), use the parameter UseBroadsoftDTG.
Determines whether the device uses the 'dtg' parameter for routing IP-
to-Tel calls to a specific Trunk Group.

[0] Disable (default)

[1] Enable
When the parameter is enabled, if the Request-URI in the received SIP
INVITE includes the 'dtg' parameter, the device routes the call to the
Trunk Group according to its value. The parameter is used instead of
1078
Mediant 500L Gateway & E-SBC
Description
Document #: LTRT-10532