AudioCodes Mediant 500L User Manual page 875

User's Manual
Tab
Remote Signaling IP
Remote RTP (IP:Port)
Call Establishment Duration
Call Duration
Call State
Fax State
Coder + PTime
Call Type
Call Establishment Method
DTMF Selected Method for Tx/Rx
Basic Channel Identifier:
Status
Call ID
Endpoint ID
Call Duration
Call Type
Version 7.2
Field
875
Description
IP address used for SIP on the IP side.
IP address and port used for RTP on the IP side.
Length of time (in seconds) it took to establish the
call.
Call duration (in seconds) from when call was
established.
Current state of the call:

"IDLE": No call.

"SETUP": Signaling to setup call (SIP INVITE).

"ALERT": Ringing at remote end (SIP 180
Ringing).

"RINGBACK": Ringback played to port.

"SESSION": Call has been answered and is
established.

"RELEASE": Call has been terminated (SIP
200 OK).
Currently, not in use.
Coder and packetization time used for the call.
Type of call:

"Voice": Voice call

"Fax": Fax call
Mode of call:

"Normal": No early media during SIP session
establishment (before call accepted).

"EarlyMedia": Media sent (e.g.,
announcements) before call accepted by
called party.
DTMF Transport method used for the call. For
configuring the transport method, see
''Configuring DTMF Transport Types'' on page
201.
Channel identifier number.
Status of port:

"Inactive": No call

"Active": Active call
See above.
ID of endpoint:

"Not Available"
Call duration (in seconds) from when call was
established.
Type of call:

"Voice": Voice call

"Fax": Fax call
Mediant 500L Gateway & E-SBC
52. System Status