AudioCodes Mediant 500L User Manual page 891

User's Manual
Threshold Crossing
Yellow to Green (alarm
cleared)
Note:
•
Forwarded calls are not considered in the calculation for ASR and NER.
•
If you don't configure thresholds for a specific metric, the device still provides
current performance monitoring values of the metric, but does not raise any
threshold alarms for it.
•
You can configure the device to perform certain actions, for example, reject calls
to the IP Group for a user-defined duration, if a threshold is crossed. For more
information, see ''Configuring Quality of Service Rules'' on page 334.
•
The section is applicable only to the SBC application.
The following procedure describes how to configure Performance Profile rules through the
Web interface. You can also configure it through ini file (PerformanceProfile) or CLI
(configure system > performance-profile).

To configure a Performance Profile rule:
1. Open the Performance Profile table (Monitor menu > Monitor tab > Performance
Monitoring folder > Performance Profile).
2. Click New; the following dialog box appears:
3. Configure the rule according to the parameters described in the table below.
4. Click Apply.
Version 7.2
hysteresis.
The change occurs if the measured metric
crosses the configured Minor threshold with
hysteresis.
Figure 55-5: Performance Profile Table - Dialog Box
55. Viewing Performance Monitoring
Calculation
891 Mediant 500L Gateway & E-SBC
Threshold based on
Example
92 (i.e., 90 + 2)