AudioCodes Mediant 500L User Manual page 356

•
Classification rules for specifying the SIP Interface as a matching characteristic of
the incoming call. This is especially useful for the single SRD-configuration
topology, where each SIP Interface represents a Layer-3 network (SIP entity).
Therefore, classification of calls to IP Groups (SIP entities) can be based on SIP
Interface. For more information, see Configuring Classification Rules on page
677.
•
Admission Control rules to apply call admission control per SIP Interface. For
more information, see ''Configuring Admission Control'' on page 673.

Gateway application:
•
Tel-to-IP Routing rules for specifying the destination SIP Interface to where you
want to route Tel-to-IP calls. For more information, see Configuring Tel-to-IP
Routing Rules on page 509.
•
IP-to-Trunk Group Routing rules for specifying the SIP Interface as a matching
characteristics for the incoming IP call.
Note: The device terminates active calls associated with a SIP Interface in the
following scenarios:
•
If you delete the associated SIP Interface.
•
If you edit any of the following fields of the associated SIP Interface: 'Application
Type', 'UDP Port, 'TCP Port', 'TLS Port' or 'SRD' fields.
•
If you edit or delete a network interface in the IP Interfaces table that is associated
with the SIP Interface.
The following procedure describes how to configure SIP interfaces through the Web
interface. You can also configure it through ini file (SIPInterface) or CLI (configure voip >
sip-interface).

To configure a SIP Interface:
1. Open the SIP Interfaces table (Setup menu > Signaling & Media tab > Core Entities
folder > SIP Interfaces).
2. Click New; the following dialog box appears:
3. Configure a SIP Interface according to the parameters described in the table below.
4. Click Apply.
User's Manual
Mediant 500L Gateway & E-SBC
356 Document #: LTRT-10532