AudioCodes Mediant 500L User Manual page 153

User's Manual
found, the packet is sent to the Default Gateway as configured for the IP interface in the IP
Interfaces table.
You can view the status of configured static routes in the IP Routing Status table. This
table can be accessed by clicking the Static Routes Status Table link located at the
bottom of the Static Routes table (see ''Viewing Static Routes Status'' on page 908).
The following procedure describes how to configure static routes through the Web
interface. You can also configure it through ini file (StaticRouteTable) or CLI (configure
network > static).

To configure static IP routes:
1. Open the Static Routes table (Setup menu > IP Network tab > Core Entities folder >
Static Routes).
2. Click New; the following dialog box appears:
3. Configure a static route according to the parameters described in the table below. The
address of the host/network you want to reach is determined by an AND operation that
is applied to the fields 'Destination' and 'Prefix Length'. For example, to reach network
10.8.x.x, enter "10.8.0.0" in the 'Destination' field and "16" in the 'Prefix Length'. As a
result of the AND operation, the value of the last two octets in the 'Destination' field
are ignored. To reach a specific host, enter its IP address in the 'Destination' field and
"32" in the 'Prefix Length' field.
4. Click Apply, and then reset the device with a save-to-flash for your settings to take
effect.
Note:
Table 12-14: Static Routes Table Parameter Descriptions
Parameter
Index
[StaticRouteTable_Index]
Version 7.2
Only static routing rules that are inactive can be deleted.
Defines an index number for the new table row.
The valid value is 0 to 29.
Note: Each row must be configured with a unique index.
Description
153 Mediant 500L Gateway & E-SBC
12. Network