AudioCodes Mediant 500L User Manual page 430


To configure a Coder Group:
1. Open the Coder Groups table (Setup menu > Signaling & Media tab > Coders &
Profiles folder > Coder Groups).
2. From the 'Coder Group Name' drop-down list, select the desired Coder Group index
number and name.
3. Configure the Coder Group according to the parameters described in the table below.
4. Click Apply, and then reset the device with a save-to-flash for your settings to take
effect.
You can delete a Coder Group, as described in the following procedure.

To delete a Coder Group:
1. From the 'Coder Group Name' drop-down list, select the Coder Group that you want to
delete.
2. Click Delete Group.
Table 20-1: Coder Groups Table Parameter Descriptions
Parameter
Coder Group Name
[AudioCodersGroups_Index]
[AudioCodersGroups_Name]
[AudioCoders_AudioCodersIndex] Index row of the coder per Coder Group
Coder Name
name
[AudioCoders_Name]
Packetization Time
p-time
[AudioCoders_pTime]
Rate
rate
User's Manual
Figure 20-1: Coder Group Table
Defines the name and index for the Coder Group.
Note: The Coder Group index/name cannot be configured.
Note: The parameter is applicable only to the ini file.
Defines the coder type. For coder names, see ''Supported Audio
Coders'' on page 431.
Note: Each coder type (e.g., G.729) can be configured only once
in the table.
Defines the packetization time (in msec) for the coder. The
packetization time determines how many coder payloads are
combined into a single RTP packet. For ptime, see ''Supported
Audio Coders'' on page 431.
Defines the bit rate (in kbps) for the coder. For rates, see
''Supported Audio Coders'' on page 431.
430
Mediant 500L Gateway & E-SBC
Description
Document #: LTRT-10532