Activation Character
This sets the character used to trigger scanning when using Character Activation
Mode. On the
value that represents the character you want to use to trigger scanning. Scan the
bar code below, then use the
numeric combination that represents that ASCII character. Scan
End Character Activation After Good Read
After a bar code is successfully detected and read from the scanner, the laser can
be programmed either to remain on and scanning, or to turn off. When End Char-
acter Activation After Good Read is enabled, the laser turns off and stops scan-
ning after a good read. If you scan Do Not End Character Activation After Good
Read, the laser remains on after a good read. Default = End Character Activation
After Good Read.
Activation After Good Read
Character Activation Laser Timeout
You can set a timeout for the length of time the laser remains on and attempting to
decode bar codes when using Character Activation Mode. Set the length (in milli-
seconds) for a timeout by scanning the bar code below, then setting the timeout
(from 1-65535 milliseconds) by scanning digits from the
page 202, then Save. Default = 5000 ms.
Voyager 1250g User Guide
ASCII Conversion Chart (Code Page 1252)
Do Not End Character
Programming Chart
Activation Character
Character Activation Laser
Timeout
on page 192, find the hex
on page 202 to read the alpha-
Save
* End Character Activation
After Good Read
Programming Chart
On
to finish.
on
53